NEW Z NC PROGRAMMABLE FOR AUTO MACHINING FROM ROUGH TO FINE FINISHING:
Total of 50 programs, each program can do a single step, 5 steps or a maximum of 10 steps machining (option) and each step includes 12 kinds of maching parameters.
By using the JOEMARS Fuzzy Logic Control System, the operator can get a total of 9600 sets of machining parameters which can also be modified at any time during sparking without affecting the stored parameters.
MACHINING SPEED:10% - 45% faster than conventional model.
LOWEST ELECTRODE WEAR:Rdduced wear in approach contact areas
SURFACE FINISHING:A much higher quality machining surface that requires a mininum amount of polishing reduced by 25%.
SHORTEST MACHINING PARAMETERS SETTING TIME:
Only input: (1) Machining materials, (2) Electrode size, (3) Electrode wear & (4) Peak current. Then the best machining parameters will be auto set to start machining from rough to final surface finishing automatically.
NEW “4A” EQUIPMENT:(Anti-Arcing Auto Adjustment):
The JOEMARS Fuzzy Logic Control System will auto monitor & adjust the machining parameters in the event of a poor machining condition. Once the condition has been cleared it will auto return to the pre-set machining parameters to achieve the best performance.
FASTER MACHINING SPEED OF ULTRA-THIN RIBS:faster machining speed of ultra-thin ribs